Independent guide. We are not an electrician or electrical contractor and do not do electrical work. Toledo requires electrical contractors to be registered with the City. Check any electrician on the City's registered electrical contractors list.

Toledo Electrician GuideIndependent consumer guide · not an electrician

Service guide

Electrical panel and service upgrades in Toledo homes

Page date: November 16, 2026.

The panel is where the utility's power enters the house and splits into circuits. In a Toledo house built before the 1960s, the original panel was sized for a very different life. This page explains when a panel or service upgrade is worth considering, what the job involves on both sides of the meter, and what it costs, with national price figures labeled as national and Toledo fees taken from the Municipal Code.

Why the question comes up so often in Toledo

The American Community Survey (2020-2024 five-year estimates) puts the median year built for Toledo housing at 1955. About 58% of housing units (77,417 of 132,728) were built before 1960, and about 40% before 1950. (Census Reporter, ACS B25034/B25035)

Angi notes that homes built in the 1940s and 1950s often have 60-amp service panels, which it calls no longer sufficient for modern devices. (Angi, rewiring) The census does not record panel sizes, so the only way to know what a given house has is to look at the main breaker or fuse block, or have it checked.

Load is the other side. About 24% of occupied Toledo homes heat mainly with electricity (28,078 of 118,662). (Census Reporter, ACS B25040) Add central air, an electric range, a dryer, and possibly an EV charger, and an older service can run short.

Signs the panel deserves a closer look

Heat, scorching or a burning smell at the panel is not a planning question. Treat it as an emergency (see the emergency page).

Replacement or upgrade?

The two terms get used loosely, so pin them down with any contractor:

A load calculation tells you which one you need. Ask for it in writing as part of any price.

National price ranges (Angi, 2026)

No published Toledo-specific panel prices were found for this guide. Angi's national numbers (Angi, panel upgrade):

Service size Panel plus installation (national)
100 amps $800 to $1,500
150 amps $1,300 to $1,600
200 amps $1,300 to $2,000
300 amps $1,800 to $3,500
400 amps $2,000 to $4,000

Angi's overall national average for a panel upgrade is $1,600, with most homeowners paying $1,200 to $2,000. Related items: subpanel $400 to $1,750, meter box installation or replacement $200 to $800, fuse box replacement $200 to $2,000. Relocating the panel adds about $300 in wiring. (Angi, panel upgrade)

The Toledo permit and fee

A panel or service change is electrical work, and Toledo requires permits for electrical work. If you hire a contractor, the contractor obtains the permit. The work must be inspected, and the City recommends getting the final inspection before final payment. (City of Toledo, permit information)

The fee is set by TMC 1307.04(c): a $60 base per unit for an existing one-, two- or three-family dwelling, plus $0.50 per amp for the electrical service, with a $75 minimum per permit. A residential "release of electrical services" is $50 per unit. Ohio's 1% residential surcharge applies on top. (TMC 1307.04, 1307.13) On those numbers, a 200-amp service in an existing single-family home works out to $160 before the surcharge. Confirm the exact assessment with the Division of Building Inspection.

The utility side

A service upgrade involves Toledo Edison as well as the City. The Municipal Code's general provisions include sections on "Service connection; inspection tag" (1301.12) and "Disconnecting and re-establishing electrical service" (1301.13). (TMC Chapter 1301) FirstEnergy runs a public "Search Electrical Inspection" tool that shows the status of an electrical inspection; FirstEnergy says the record drops out of the search once construction is complete and the meter has been set. (FirstEnergy)

Toledo Edison's standard residential supply is 120/240 volt, three-wire, single phase. (Toledo Edison tariff) Ask the contractor who coordinates the disconnect, the City inspection and the reconnect, and how long the house will be without power and who schedules each step.

Before you sign

  1. Confirm the contractor is on the City of Toledo registered electrical contractor list. (City of Toledo) See how to check a Toledo electrician.
  2. Ask for a load calculation and a written scope that says replacement or service upgrade, and which amperage.
  3. Ask whether the meter base, service-entrance cable, grounding and bonding are included.
  4. Ask whether the permit fee is in the price and when the inspections happen.
  5. If an EV charger or heat pump is planned in the next few years, say so now, so the panel has room for it.

Related guides

Sources

Sources cited on this page.

  1. Census Reporter, ACS B25034/B25035
  2. Angi, panel upgrade
  3. Angi, rewiring
  4. TMC 1307.04, 1307.13
  5. TMC Chapter 1301
  6. City of Toledo, permit information
  7. FirstEnergy
  8. Toledo Edison tariff
  9. City of Toledo